LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Diagnosis & Overhaul - 41TE Automatic Transmission - Except Coupe) >> 41TE Automatic Transaxle >> Removal

41TE Automatic Transaxle: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If transaxle assembly is being replaced or overhauled (clutch and/or seal replacement), it is necessary to perform the TCM Quick Learn Procedure. (Refer to STANDARD PROCEDURE )
  1. Disconnect battery cable.
  2. Remove air cleaner assembly.
  3. Remove dipstick tube. Plug hole to prevent debris from entering transaxle.
  4. Using Tool 8875A, disconnect the transmission cooler line quick-connect fittings. (Refer to TRANSMISSION )
  5. Disconnect Solenoid/Pressure Switch Assy. connector.
  6. Disconnect Transmission Range Sensor connector.
  7. Disconnect Input Speed Sensor connector.
  8. Disconnect Output Speed Sensor connector.
  9. Disconnect shift cable from manual valve lever and bracket.
  10. Disconnect Crankshaft Position Sensor.
  11. Remove throttle body support bracket.
  12. Disconnect Oxygen Sensor harness retainer from transaxle case.
  13. Remove rear mount bracket-to-transaxle case bolts.
  14. Remove starter upper bracket-to-block bolt.
  15. Raise vehicle.
  16. Remove halfshafts. Refer to Differential and Driveline.
  17. Remove rear mount bracket lower bolt.
  18. Remove rear mount thru-bolt.
  19. Remove rear mount-to-cross member bolts.
  20. Remove rear mount and bracket.
  21. Remove front mount thru-bolt.
  22. Remove front mount to radiator lower crossmember bolts.
  23. Remove front mount bracket to block and transaxle.
  24. Remove front mount bracket and mount.
  25. Remove starter lower bolt and starter motor assembly.
  26. Remove converter dust shield.
  27. Remove torque converter bolts.
  28. Support engine/transaxle with screw jack and wood block on engine oil pan.
  29. Remove left mount bracket-to-transaxle bolts.
  30. Carefully lower engine/transaxle assembly to gain access to and remove transaxle-to-engine bolts.
  31. With aid of helper or transmission jack, remove transaxle assembly from vehicle.
scientia non olet · About LEMON Manuals