Speed Sensor - Output: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect battery negative cable.
Raise vehicle on hoist.

Disconnect output speed sensor connector. See Fig 1.

Fig 1: Transmission Connectors

Courtesy of DAIMLERCHRYSLER CORP.

1 - SOLENOID PACK CONNECTOR

2 - INPUT SPEED SENSOR CONNECTOR

3 - OUTPUT SPEED SENSOR CONNECTOR

4 - TRANSMISSION RANGE SENSOR CONNECTOR

Unscrew and remove output speed sensor. See Fig 2.
Inspect speed sensor o-ring and replace if necessary. See Fig 3.

Fig 2: Output Speed Sensor

Courtesy of DAIMLERCHRYSLER CORP.

1 - OUTPUT SPEED SENSOR

Fig 3: O-Ring Location

Courtesy of DAIMLERCHRYSLER CORP.

1 - OUTPUT SPEED SENSOR

2 - O-RING