LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Diagnosis & Overhaul - 40TE Automatic Transmission - Except Coupe) >> Gearshift Mechanism >> Removal

Gearshift Mechanism: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable and isolate.
  2. Remove the gearshift knob set screw and knob. See Fig 1.
    Fig 1: Gearshift Knob
    GC0031287Courtesy of DAIMLERCHRYSLER CORP.
    1 - GEARSHIFT KNOB
    2 - SET SCREW
    3 - GEARSHIFT MECHANISM
  3. Remove gearshift bezel. See Fig 2. Disconnect range indicator lamp connector.
    Fig 2: Gearshift Bezel
    GC0031286Courtesy of DAIMLERCHRYSLER CORP.
    1 - CENTER CONSOLE ASSEMBLY
    2 - GEARSHIFT BEZEL
    3 - LAMP CONNECTOR
  4. Remove center console assembly. See Fig 3.
    Fig 3: Center Console Assembly
    GC0031282Courtesy of DAIMLERCHRYSLER CORP.
    1 - CENTER CONSOLE
    2 - SCREW
    3 - IF EQUIPPED
    4 - IF EQUIPPED
    5 - PARK BRAKE HANDLE
  5. Loosen nut on shift cable adjust lever.
  6. Using a flat blade pry tool, remove the shifter cable core end from the shift lever pin. See Fig 4.
  7. Using a flat blade pry tool, pry the cable conduit clip up from the shifter bracket. Pull up on the cable conduit and remove from bracket. See Fig 4.
    Fig 4: Gearshift Cable at Floor Shifter-Typical
    GC0031296Courtesy of DAIMLERCHRYSLER CORP.
    1 - CLIP
    2 - CABLE
    3 - CONDUIT BRACKET
    4 - SHIFT PIN
  8. Release interlock cable adjuster end by inserting pointed object into shift bracket to disengage lock. See Fig 5. Unsnap the shifter/ignition interlock cable adjuster end from the slot in the gearshift mechanism bracket and disconnect cable core from shifter assembly. See Fig 6.
    Fig 5: Release Cable from Bracket at Retainer Lock
    GC0031297Courtesy of DAIMLERCHRYSLER CORP.
    1 - RELEASE CABLE HERE
    Fig 6: Interlock Cable at Floor Shifter Assembly
    GC0031298Courtesy of DAIMLERCHRYSLER CORP.
    1 - SHIFTER ASSEMBLY
    2 - INTERLOCK CABLE
  9. Disconnect Autostick connector (if equipped). See Fig 7.
    Fig 7: Autostick Connector (if equipped)
    GC0031299Courtesy of DAIMLERCHRYSLER CORP.
    1 - AUTOSTICK CONNECTOR
  10. Remove the five nuts at the base of the shifter assembly. Remove assembly from vehicle. See Fig 8.
Fig 8: Shifter Assembly
GC0031300Courtesy of DAIMLERCHRYSLER CORP.
1 - NUTS (5)
2 - SHIFTER ASSEMBLY