Washer Reservoir: Removal
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative remote cable.
- Disconnect washer fluid hose at in-line connector on top of the right shock tower.
- Partially remove bumper fascia as needed to gain access to the reservoir. Refer to REMOVAL .
- Disconnect wire connector from washer pump and harness mounting tab. See Fig 1.
1 - RESERVOIR 2 - WASHER PUMP - Remove washer reservoir mounting bolts.
- Slide rearward and drop down and away from vehicle.
- Drain washer fluid from reservoir into an appropriate container.
- Disconnect the washer hose from the reservoir.