LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Wiper System & Washer System - Except Coupe) >> Washer Reservoir Pump >> Removal

Washer Reservoir Pump: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative remote cable.
  2. Partially remove the bumper fascia as needed to gain access to the reservoir pump. Refer to REMOVAL .
  3. Place a drain bucket below the reservoir to catch any washer solvent that may leak out.
  4. Firmly grasping pump by hand twist and pull away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
  5. Remover rubber grommet from reservoir and throw away.
scientia non olet · About LEMON Manuals