LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Instrument Cluster - Except Coupe) >> Vacuum Fluorescent Display >> Installation

Vacuum Fluorescent Display: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the VF-display onto the dial assembly and install the two screws.
  2. Carefully push the dial assembly into the housing to make the connection with the PC-board.
  3. Install the six attachment screws and then install cluster mask/lens to the instrument cluster.
  4. Carefully plug the connector into the printed circuit board.
  5. Install the cover and the six cluster back cover retaining screws.
  6. Install the instrument cluster into vehicle. Refer to INSTALLATION .
  7. Connect the negative battery cable remote terminal to the remote battery post.
scientia non olet · About LEMON Manuals