Removal - 2.7L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The sensors screws into the cylinder block, directly below the intake manifold.

Remove intake manifold plenum refer to REMOVAL .
Remove the passenger side cylinder head, refer to REMOVAL .
Disconnect electrical connector from knock sensor. See Fig 1.

Fig 1: Knock Sensor 2.7 L
Courtesy of DAIMLERCHRYSLER CORP.

1 - KNOCK SENSOR
Use a crows foot socket to remove the knock sensors.