LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Ignition Control - Except Coupe) >> Knock Sensor >> Installation >> Installation - 4 Cylinder

Installation - 4 Cylinder

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The knock sensor threads into the side of the cylinder block in front of the starter. See Figure.

  1. Install knock sensor. Tighten knock sensor to 10 N.m (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing improper spark control. 
  2. Attach electrical connector to knock sensor.
scientia non olet · About LEMON Manuals