LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Ignition Control - Except Coupe) >> Camshaft Position Sensor >> Removal >> Removal - 2.7L

Removal - 2.7L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The camshaft position sensor is mounted in the front of the head.

  1. Disconnect electrical connector from sensor.
  2. Remove camshaft position sensor screw.
  3. Without pulling on the connector, pull the sensor out of the chain case cover. See Fig 1.
Fig 1: Cam Sensor Location 2.7L
GC0031230Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals