LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Power Distribution - Except Coupe) >> Power Distribution Center >> Removal

Power Distribution Center: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The Power Distribution Center (PDC) is serviced as a unit with the headlamp/dash wire harness. If any internal circuit of the PDC or the PDC housing is faulty or damaged, the entire PDC and headlamp/dash wire harness unit must be replaced.

  1. Disconnect and isolate the battery negative cable.
  2. Remove the Air Inlet System (housing and resonator).
  3. Disconnect each of the wire harness connectors.
  4. Remove the fasteners that secure each of the wire harness ground eyelets to the vehicle body and chassis components.
  5. Disengage each of the retainers that secure the engine compartment wire harness to the vehicle body and chassis components.
  6. Remove the nut retaining the PDC to its mounting bracket.
  7. Remove the PDC and the wire harness from the engine compartment as a unit.
scientia non olet · About LEMON Manuals