LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Power Distribution - Except Coupe) >> Power Distribution Center >> Installation

Power Distribution Center: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the PDC in the engine compartment.
  2. Align the PDC mounting slots with the blades on the PDC mounting bracket.
  3. Install the mounting nut onto the PDC.
  4. Route the wire harness from the PDC through the engine compartment, engaging each of the harness retainers to the mounting provisions in the vehicle body and chassis components.
  5. Install and tighten the fasteners that secure each of the engine compartment wire harness ground eyelets to the vehicle body and chassis components.
  6. Reconnect each of the wire harness connectors.
  7. Connect the battery negative cable.
scientia non olet · About LEMON Manuals