Installation - 2.7L
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Install generator. See Figure.
- Install the 2 upper bolts but do not tighten.
- Install the engine dip stick tube.
- Connect the A/C pressure switch and A/C clutch electrical connectors.
- Connect the B+ terminal and field connectors. See Figure.
- Raise vehicle and support.
- Install the lower bolt and tighten.
- Install the accessory drive belt, refer to COOLING - EXCEPT COUPE .
- Install the accessory drive splash shield.
- Lower the vehicle.
- Tighten the 2 upper mounting bolts.
- Connect the negative battery cable.