LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Weatherstrip/Seals >> Quarter Panel Outer Belt Weatherstrip/Molding >> Installation

Quarter Panel Outer Belt Weatherstrip/Molding: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position quarter panel outer belt weatherstrip/molding on vehicle.
  2. Push outer belt weatherstrip/molding downward until weatherstrip/molding is fully seated.
  3. Install screws attaching outer belt weatherstrip to outer quarter panel.
  4. Tighten fasteners for upper belt molding.
  5. Install quarter trim panel.
  6. Raise and secure convertible top.
scientia non olet · About LEMON Manuals