LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Weatherstrip/Seals >> Header Weatherstrip Retainer/Molding >> Installation

Header Weatherstrip Retainer/Molding: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean any residual seal material from header panel.
  2. Position header weatherstrip retainer on vehicle.
  3. Install screws attaching retainer to header panel. Install center screw first and then work outward.
  4. Install screws attaching A-pillar weatherstrip retainer to header retainer.
  5. Install L foam in upper corner starting at upper screw on the A-pillar retainer.
  6. Install L foam in upper corner starting at upper screw on A-pillar.
  7. Install header and A-pillar weatherstrip.
  8. Lower and secure convertible top.
scientia non olet · About LEMON Manuals