LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Weatherstrip/Seals >> DECKLID Opening Weatherstrip >> Removal

DECKLID Opening Weatherstrip: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release decklid latch and open decklid.
  2. Disconnect and isolate the battery negative cable.
  3. Remove four push pins and remove the latch cover.
  4. Disconnect the three harness electrical connectors and remove the ground strap screw.
  5. Tape the wires together and tape in one chase wire.
  6. Route the wires through the decklid.
  7. Pull decklid opening weatherstrip from decklid opening flange. See Fig 1.
  8. Remove decklid opening weatherstrip from vehicle.
Fig 1: Decklid Opening Weatherstrip
GC0031545Courtesy of DAIMLERCHRYSLER CORP.
1 - TRUNK OPENING WEATHERSTRIP
2 - TRUNK OPENING FLANGE
scientia non olet · About LEMON Manuals