LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Weatherstrip/Seals >> A-Pillar Weatherstrip Retainer And Molding >> Installation

A-Pillar Weatherstrip Retainer And Molding: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean A-pillar of any seal material residue.
  2. Position A-pillar molding to vehicle.
  3. Install screws attaching A-pillar molding to A-pillar.
  4. Position A-pillar weatherstrip retainer on A-pillar.
  5. Install screws attaching retainer to A-pillar. Install middle screw first and then work outward.
  6. Install header and A-pillar weatherstrip.
  7. Lower and secure convertible top.
scientia non olet · About LEMON Manuals