Section 82 (Interior & Exterior - Except Coupe): Sunroof: Sunshade: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Place the sunroof glass panel in the vent position.
Move the sunshade to the closed position
From the outside of the vehicle, using a flat blade tool, disengage the rear sunshade guides. Pushing the guide toward the center of the vehicle. See Fig 1. Raise up on sunshade and slide it rearward out through the opening. See Fig 2. Release the front two guides and remove sunshade from the vehicle. See Fig 3.
CAUTION: Use care not to crease the sunshade when removing or installing.
Remove the sunshade handle from sunshade by compressing the back side of the handle together and pull the handle out.

Fig 1: Sunshade Rear Guide

Courtesy of DAIMLERCHRYSLER CORP.

1 - GLASS PANEL

2 - SUNSHADE REAR GUIDE

Fig 2: Sunshade Removal

Courtesy of DAIMLERCHRYSLER CORP.

1 - GLASS PANEL

2 - SUNSHADE REMOVAL

Fig 3: Sunshade Front Guide

Courtesy of DAIMLERCHRYSLER CORP.

1 - SUNSHADE FRONT GUIDE

2 - SCREWDRIVER DEPRESSING FRONT GUIDE