Sunroof Glass Panel: Installation
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Position glass panel on to mechanism.
- Start the six attaching screws.
- Close glass.
- Center glass in opening by running a business card around the glass.
- Adjust front height of glass, just below roof panel.
- Tighten front two screws.
- Adjust rear height of glass, just above roof panel.
- Tighten remaining screws.
- Verify sunroof operation and alignment. Check fit and adjust as necessary, (Refer to SUNROOF GLASS PANEL ).