LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Sunroof >> Sunroof Glass Panel >> Adjustments >> Adjustment

Sunroof Glass Panel: Adjustments: Adjustment

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the sunshade rearward to the open position.
  2. Move the sunroof glass panel to the fully closed position.
  3. Loosen the forward and center screws on each side enough to make the front adjustment.
  4. Adjust the front of the sunroof glass panel 1 mm (1/32 inch) below the top surface of the roof panel.
  5. Tighten the front two screws.
  6. Loosen the rear screws on each side enough to make the rear adjustment.
  7. Adjust the rear of the sunroof glass panel 1 mm (1/32 inch) above the top surface of the roof panel.
  8. Tighten the rear two screws.
  9. Check for proper fit. If not OK, repeat glass panel adjustment. If OK, tighten the center two screws.
scientia non olet · About LEMON Manuals