LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Seats >> Seat Back Recliner >> Removal >> Removal - Jr-27 Only

Removal - Jr-27 Only

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove seat from vehicle (Refer to BODY/SEATS/SEAT - REMOVAL) .
  2. Remove seat back from lower seat frame (Refer to BODY/SEATS/SEAT BACK - REMOVAL) .
  3. Remove upper recliner handle.
  4. Remove seat back cover until the screws attaching the upper recliner mechanism to the seat back frame can be accessed.
  5. Remove rubber bellows covering lower part of seat back frame.
  6. Remove screws attaching upper recliner mechanism to seat frame.
  7. Remove bolts attaching recliner housing to seat frame.
  8. Push upper recliner mechanism into seat frame with handle shaft facing the front of the seat frame.
    NOTE: Do not reuse bolts holding recliner housing to seat frame. Verify availability prior to proceeding.
  9. Pull recliner housing and upper recliner handle mechanism downward and out through bottom of seat frame. See Fig 1.
Fig 1: Recliner Housing
GC0031524Courtesy of DAIMLERCHRYSLER CORP.
1 - UPPER RECLINER MECHANISM
2 - RECLINER HOUSING
3 - RECLINER CABLE
scientia non olet · About LEMON Manuals