LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Seats >> Rear Seat Back Cover >> Installation - Jr-27 Only

Installation - Jr-27 Only

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position seat cover to seat back frame and seat back foam.
  2. Align notch in center of seat back cover vertical seam to center hog ring locator.
  3. Install a hog ring at each hog ring location, center first, attaching seat back cover seam to wires in seat back foam.
  4. Repeat the above steps for the opposite inboard vertical seam, both outboard vertical seams, and the lower horizontal seam.
  5. Install hog rings at each hog ring locator, center first, to attach ends of vertical portions of U-shaped wires to vertical foam wires.
  6. Align notch in center of upper horizontal seat cover seam to center hog ring location.
  7. Install a hog ring at each hog ring locator to hold upper horizontal seam wire to wire in seat back foam.
  8. Install hog rings attaching seat cover seam wires to seat frame.
  9. Pull seat cover over seat back frame and seat back foam.
  10. Install hog rings at hog ring locators around perimeter of seat back cushion attaching seat cover to seat back frame.
  11. Install rear seat back to vehicle (Refer to BODY/SEATS/REAR SEAT BACK - INSTALLATION) .
scientia non olet · About LEMON Manuals