Removal - Manual - Jr-27 Only
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Move seat to full forward position.
- Remove rear inboard bolt attaching seat to floor pan.
- Remove rear outboard bolts attaching seat to side sill pylon.
- Position seat in full rearward position.
- Remove front inboard and outboard bolts holding seat to floor pan crossmember. See Fig 1.
- Tilt seat rearward and disconnect seat belt pretensioner wire connector.
- Remove seat from vehicle.
| 1 - FRONT SEAT |
| 2 - FLOOR PAN CROSSMEMBER |
| 3 - FRONT SEAT TRACK |