Instrument Panel Outboard Bezel: Removal
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative remote cable.
- Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the instrument panel outboard switch bezel. See Fig 1.
- Disconnect the wire connector.
- Remove bezel from vehicle.
- Push in the sides of the power mirror switch to release it from the bezel.
| 1 - WIRE CONNECTORS |
| 2 - OUTBOARD SWITCH BEZEL |