Instrument Panel Center Bezel: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the battery negative remote cable.
Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the edge of the instrument panel center bezel and pull outward. See Fig 1.
Disconnect the wire connector to the HVAC control.
Remove the instrument panel center bezel from the vehicle.

Fig 1: Instrument Panel Center Bezel

Courtesy of DAIMLERCHRYSLER CORP.

1 - CENTER BEZEL

2 - INSTRUMENT PANEL