Section 82 (Interior & Exterior - Except Coupe): Hood: Hinge: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, paint new hinge before installation.
Place hinge in position on vehicle.
Install bolts to attach hood hinge to load beam inner.
Install bolts to attach hood to hinge.
Align all marks and secure bolts.
Tighten bolts to 28 N.m (20 ft. lbs.) torque.
The hood should be aligned to 4 mm (0.160 in.) gap to the front fenders and flush across the top surfaces along fenders. Shims can be added or removed under hood hinge to achieve proper hood height.
Install cowl cover (Refer to BODY/EXTERIOR/COWL GRILLE - INSTALLATION) .
Verify hood latch operation. Adjust as necessary.