LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Exterior >> Tape Stripe >> Removal - Adhesives

Removal - Adhesives

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark reference points before removing.
  2. Using a heat gun gently apply heat in a circular motion to loosen the adhesive bond.
  3. Using the trim stick C 4755 or equivalent, lift up and peel away badging /tape from panel, using a heat gun as you go.
  4. Clean off all traces of adhesive from the panel(s) with a general purpose adhesive remover.
scientia non olet · About LEMON Manuals