LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Exterior >> Exterior Name Plates >> Removal - Foam Tape

Removal - Foam Tape

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark reference points before removing.
  2. Using a heat gun gently apply heat in a circular motion to loosen the adhesive bond.
  3. Using a trim stick C 4755 or equivalent, gently pry up at corners and remove.
  4. Clean off all traces of adhesive or double sided tape from the panel with a general purpose adhesive remover.
scientia non olet · About LEMON Manuals