Body Side Moldings: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Warm the affected body side molding and body metal to approximately 38° C (100° F) using a suitable heat lamp or heat gun.
Pull body side molding from vehicle. See Fig 1.
Remove adhesive tape residue from surface of vehicle.

Fig 1: Body Side Molding

Courtesy of DAIMLERCHRYSLER CORP.

1 - QUARTER PANEL

2 - DOOR

3 - BODYSIDE MOLDING