Window Regulator: Removal
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Remove door waterdam.
- Remove glass from regulator roller channel. Secure glass in the up position in the door frame.
- Disconnect power window motor wire connector, if equipped.
- Loosen screw attaching regulator scissor channel to door panel. See Fig 1.
- Remove screw and bolt heads from keyhole slots in door panel.
- Loosen bolts attaching regulator to door panel.
- Remove regulator from door panel.
- Slide regulator rearward and rotate forward end of roller channel through access hole in door panel.
| 1 - REAR DOOR |
| 2 - MOUNTING SLOTS |
| 3 - REGULATOR |
| 4 - BOLTS |
| 5 - BOLTS |
| 6 - MOTOR |
| 7 - ELECTRICAL CONNECTOR |
| 8 - MOUNTING SLOTS |