LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Deck Lid/Hatch/Liftgate/Tailgate >> Hinge >> Installation

Deck Lid/Hatch/Liftgate/Tailgate: Hinge: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place hinge in the mark outline of hinge on quarter panel trough and inside of decklid to aid in positioning hinge.
  2. Install hinge to vehicle.
  3. Install bolts attaching hinge to quarter panel trough.
  4. Tighten bolts to 22.5 N.m (200 in. lbs.) torque.
  5. Place decklid against padded block and hold it steady.
  6. Install bolts attaching hinge to decklid.
  7. Tighten bolts to 22.5 N.m (200 in. lbs.) torque.
  8. Install prop-rod to mounting studs.
  9. Install the gas prop-rod lock caps.
  10. Remove the padded block between the deck panel and the decklid.
  11. Close decklid.
scientia non olet · About LEMON Manuals