LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Convertible Top >> Hydraulic Lines >> Removal

Hydraulic Lines: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move top to the down position
  2. Disconnect battery negative terminal.
  3. Remove rear seat cushion and rear seat back.
  4. Remove both quarter trim panels.
  5. Disconnect pump wire connector.
  6. Remove motor from floor panel. Holding motor/pump assembly with reservoir up, squeeze fill plug to release any air pressure from system.
  7. Disconnect hydraulic line from hydraulic cylinders.
  8. Disconnect hydraulic line from hydraulic pump.
  9. Remove hydraulic line from vehicle. Carefully drain hydraulic line and properly dispose of fluid and component.
scientia non olet · About LEMON Manuals