LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Convertible Top >> Hydraulic Lines >> Installation

Hydraulic Lines: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position hydraulic line to vehicle.
  2. Connect hydraulic line to hydraulic pump. Tighten fittings to 11 to 12 N.m (98 to 106 in. lbs.) torque.
  3. Connect hydraulic line to hydraulic cylinders. Tighten fittings to 8.5 to 9.5 N.m (75 to 84 in. lbs.) torque.
  4. Connect battery negative terminal.
  5. Bleed system (Refer to BODY/CONVERTIBLE TOP - ADJUSTMENTS - HYDRAULIC MOTOR/PUMP BLEEDING PROCEDURES) .
  6. Verify system operation.
  7. Install quarter trim panels.
  8. Install rear seat cushion and rear seat back. Ensure the rear seat back will not pinch and/or kinks the hydraulic lines.
scientia non olet · About LEMON Manuals