Cd Changer: Installation
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Connect wire harness connector to CD changer.
- Insert CD changer into instrument panel. Make sure that bumper on back of changer is inserted into instrument panel opening.
- Pull radio from instrument panel far enough to reach behind. Pull CD changer cable through radio opening while inserting changer into instrument panel.
- Install radio.
- Install screws to radio and CD changer.
- Install lower center trim bezel.
- Connect battery negative cable.