LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Audio System - Except Coupe) >> Antenna Body & Cable >> Installation

Antenna Body & Cable: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert antenna lead to base of antenna body.
  2. Push antenna body up through the rubber grommet.
  3. Install screw into mounting bracket. Tighten screw to 12 N.m (106 in. lbs.).
  4. Install antenna mast. Tighten to 12 N.m (106 in. lbs.) Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base. 
  5. Install trunk liner.
  6. Connect battery negative cable.
scientia non olet · About LEMON Manuals