LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (HVAC Systems - Except Coupe) >> Plumbing >> A/C Evaporator >> Installation

A/C Evaporator: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  1. Install the A/C evaporator into the lower half of the HVAC housing. Make sure that the evaporator drain is clean and unrestricted and that the evaporator insulator is properly installed.
    NOTE: The A/C evaporator is manufactured with three holes for evaporator temperature sensor probe insertion. Always insert the probe into the uppermost hole.
  2. Install the evaporator temperature sensor probe into the A/C evaporator.
  3. Assemble the HVAC housing (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HVAC HOUSING - ASSEMBLY) .
  4. Install the HVAC housing (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HVAC HOUSING - INSTALLATION) .
scientia non olet · About LEMON Manuals