LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (HVAC Systems - Except Coupe) >> Controls >> Mode Door Actuator >> Operation

Mode Door Actuator: Operation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The mode door actuator is connected to the body control module (BCM) through the vehicle electrical system by a dedicated five-wire lead and connector of the HVAC wire harness. The mode door actuator can move the panel-air door and the floor/defrost-air door (mode-air doors) in two directions. A potentiometer within the actuator allows the BCM to know the exact position of the mode-air doors at all times.

The mode door actuator can be diagnosed using a DRBIII® scan tool. Refer to BODY DIAGNOSTIC PROCEDURES - EXCEPT COUPE article for more information.

The mode door actuator cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.