LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (HVAC Systems - Except Coupe) >> Controls >> Blower Motor Power Module >> Installation

Blower Motor Power Module: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the blower motor power module into the bottom of the HVAC housing.
  2. Install the two screws that secure the blower motor power module to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the two wire connectors to the blower motor power module.
  4. Install the silencer panel to the right side of the instrument panel (Refer to BODY/INSTRUMENT PANEL/RIGHT IP SILENCER PANEL - INSTALLATION) .
  5. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals