Blower Motor Power Module: Description

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

A blower motor power module is used on this model when it is equipped with the optional automatic temperature control (ATC) heating-A/C system. Models equipped with the standard manual temperature control (MTC) heating-A/C system use a blower motor resistor, instead of the blower motor power module. See Fig 1.(Refer to HEATING & AIR CONDITIONING/CONTROLS/BLOWER MOTOR RESISTOR - DESCRIPTION) .

The blower motor power module is mounted to the bottom of the HVAC housing, directly behind the glove box. The blower motor power module consists of a molded plastic mounting plate with two integral connector receptacles. Concealed behind the mounting plate is the power module electronic circuitry and a large finned heat sink. The blower motor power module is accessed for service by removing the passenger side silencer panel.

Fig 1: Blower Motor Power Module

Courtesy of DAIMLERCHRYSLER CORP.

1 - BLOWER MOTOR POWER MODULE

2 - HEAT SINK