Ambient Temperature Sensor: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Remove the push pin that secures the ambient temperature sensor to the inside of the front bumper beam. See Fig 1.
Disconnect the wire harness connector from the ambient temperature sensor and remove the sensor.

Fig 1: Removing/Installing Ambient Air Temperature Sensor

Courtesy of DAIMLERCHRYSLER CORP.

1 - AMBIENT TEMPERATURE SENSOR

2 - WIRING HARNESS CONNECTOR

3 - PUSH PIN