LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Differential & Driveline - Except Coupe) >> Half Shaft >> Diagnosis And Testing >> HALFSHAFT Diagnosis >> Noise And/Or Vibration In Turns

Noise And/Or Vibration In Turns

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

A clicking noise and/or a vibration in turns could be caused by one of the following conditions:

  1. Damaged outer C/V or inner tripod joint seal boot or seal boot clamps. This will result in the loss and/or contamination of the joint grease, resulting in inadequate lubrication of the joint.
  2. Noise may also be caused by another component of the vehicle coming in contact with the halfshafts.
scientia non olet · About LEMON Manuals