LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Mechanical Brake System - Base (Service Information) - Except Coupe) >> Shoes - Parking Brake >> Installation

Shoes - Parking Brake: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install front brake shoe and hold down clip. See Figure.
  2. Install the rear park brake shoe and the park brake shoe upper return spring. See Figure.
  3. Pull rear brake shoe over anchor block until properly located on adapter.
  4. Install the park brake lower return spring. See Figure.
  5. Install the adjuster between the park brake shoes. Adjuster must be installed with the star wheel toward the rear of the vehicle. See Figure.
  6. Install hold down clip on rear park brake shoe. See Figure.
  7. Adjust park brake shoes to an outside diameter of 171 mm (6.75 inch).
  8. Install hub/bearing on knuckle.
  9. Install A NEW  hub/bearing retaining nut. Tighten the hub/bearing retaining nut to a torque of 250 N.m (185 ft. lbs.).
  10. Install dust cap on hub/bearing.
  11. Install rotor.
  12. Install rear disc brake caliper on adapter (See Brake Shoe Removal).
  13. Install wheel and tire.
  14. Tighten wheel stud nuts to 135 N.m (100 ft.lbs.).
scientia non olet · About LEMON Manuals