LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Mechanical Brake System - Base (Service Information) - Except Coupe) >> Master Cylinder >> Installation

Master Cylinder: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position master cylinder assembly on studs of power brake unit, aligning push rod on power brake vacuum booster with piston of master cylinder.
  2. Install the 2 master cylinder to power brake vacuum booster mounting nuts. Tighten both nuts to a torque of 26 N.m (230 in. lbs.).
  3. Connect brake tubes to master cylinder primary and secondary ports. Then tighten the tube nuts to a torque of 17 N.m (145 in. lbs.).
  4. Connect wiring harness connector to brake fluid level switch.
  5. Fill master cylinder with clean, fresh Mopar(R) Brake Fluid or equivalent.
  6. Road test vehicle to ensure proper operation of brakes.
scientia non olet · About LEMON Manuals