LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Mechanical Brake System - Base (Service Information) - Except Coupe) >> Disc Brake Caliper - Rear >> Assembly >> Assembly - Caliper Guide Pin Bushings (Disc/Disc Brakes)

Assembly - Caliper Guide Pin Bushings (Disc/Disc Brakes)

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fold the guide pin bushing in half lengthwise.
    NOTE: To avoid damage to the bushing, do not use a sharp object to install the guide pin bushing.
  2. Insert the folded bushing into the caliper mounting boss using your fingers from the rear of the caliper.
  3. Unfold the bushing using your fingers or a wooden dowel until the bushing is fully seated into the caliper housing. The bushing flanges should be seated evenly on both sides of the bushing hole.
  4. Lubricate inside surfaces of bushing using Mopar(R) Dielectric Grease or equivalent.
  5. Repeat the procedure for remaining bushing.
scientia non olet · About LEMON Manuals