LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Frame & Bumpers - Except Coupe) >> Rear Fascia >> Installation >> Installation - Sedan Jr-41

Installation - Sedan Jr-41

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the energy management foam is properly installed in rear fascia.
  2. Position fascia on vehicle.
  3. Slide fascia forward to engage hooks attaching fascia to bottom of quarter panel.
  4. Install push-in fastener attaching center of fascia to rear closure panel.
  5. Install push-in fasteners attaching decklid slam bumpers to top of fascia.
  6. Install new nut and washer to fascia to quarter panel bracket located in the trunk area.
  7. Install screws attaching fascia to quarter panel at wheelhouse opening.
  8. Install fasteners attaching fascia to rear wheelhouse splash shields.
  9. Engage license plate wire connector to left tail lamp.
  10. Install tail lamps.
scientia non olet · About LEMON Manuals