LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Frame & Bumpers - Except Coupe) >> Rear Bumper Reinforcement >> Installation

Rear Bumper Reinforcement: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position rear bumper reinforcement on vehicle.
  2. Install nuts attaching bumper reinforcement to frame rail. Use marks made previously to properly position bumper reinforcement.
  3. Tighten nuts to 28 N.m (250 in. lbs.) torque.
  4. Install rear fascia.
scientia non olet · About LEMON Manuals