Removal - 2.4L
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Drain cooling system (Refer to COOLING/ENGINE - STANDARD PROCEDURE) .
- Raise vehicle on hoist.
- Disconnect lower radiator hose and heater hose from the inlet tube. See Fig 1.
- Remove fasteners that hold the inlet tube to the block.
- Rotate inlet tube while removing from the engine block. See Fig 1.
| 1 - O-RING |
| 2 - TO HEATER |
| 3 - WATER PUMP INLET TUBE |