LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Except Coupe) >> Engine >> Water Pump Inlet Tube >> Removal >> Removal - 2.0L

Removal - 2.0L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system (Refer to COOLING/ENGINE - STANDARD PROCEDURE) .
  2. Raise vehicle on hoist.
  3. Remove Air Conditioning Compressor/Generator accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  4. Disconnect and remove generator.
  5. Remove generator bracket.
  6. Disconnect lower radiator hose and heater hose from the inlet tube. See Figure.
  7. Remove fasteners that hold the inlet tube to the block.
  8. Rotate inlet tube while removing from the engine block. See Figure.
scientia non olet · About LEMON Manuals