Removal - 2.4L
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Partially drain cooling system below thermostat housing level.
- Remove thermostat (Refer to COOLING/ENGINE/ENGINE COOLANT THERMOSTAT - REMOVAL) .
- Disconnect engine coolant temperature sensor connector.
- Disconnect heater supply hose.
- Remove housing attaching bolts. See Fig 1.
- Remove housing and gasket. See Fig 1.
| 1 - THERMOSTAT HOUSING |
| 2 - COOLING SYSTEM BLEED VALVE |
| 3 - BOLTS |
| 4 - ENGINE COOLANT TEMPERATURE SENSOR |