LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Except Coupe) >> Engine >> Thermostat Housing >> Removal >> Removal - 2.0L

Removal - 2.0L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Partially drain cooling system below thermostat housing level.
  3. Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  4. Disconnect and remove generator.
  5. Remove thermostat (Refer to COOLING/ENGINE/ENGINE COOLANT THERMOSTAT - REMOVAL) .
  6. Disconnect engine coolant temperature sensor connector.
  7. Disconnect heater supply hose.
  8. Remove housing attaching bolts. See Figure.
  9. Remove housing and gasket. See Figure.
scientia non olet · About LEMON Manuals