LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Except Coupe) >> Engine >> Thermostat Housing >> Installation >> Installation - 2.4L

Installation - 2.4L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all gasket sealing surfaces.
  2. Install gasket and housing. See Figure. Tighten bolts to 28 N.m (20 ft. lbs.).
  3. Reconnect heater supply hose.
  4. Reconnect engine coolant temperature sensor connector.
  5. Install thermostat (Refer to COOLING/ENGINE/ENGINE COOLANT THERMOSTAT - INSTALLATION) .
  6. Fill cooling system (Refer to COOLING/ENGINE - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals